KTM 350 EXC-F 2017, Руководство пользователя, Страница: 105 / 129

18 SERVICE WORK ON THE ENGINE
103
K00578-10
Condition
The engine is at operating temperature.
–
Check the engine oil level.
Info
After switching off the engine, wait one minute before checking the
level.
The engine oil is at a level between the lower edge

and the middle of the
level viewer

.
» If the engine oil is not up to the lower edge

of the level viewer:
–
Add engine oil. ( p. 105)
18.3 Changing the engine oil and oil filter, cleaning the oil screen
Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable regu-
lations.
Info
Drain engine oil with engine at operating temperature.
Preparatory work
–
Park the motorcycle on a level surface.
K00567-10
Main work
–
Place a suitable container under the engine.
–
Remove oil drain plug

with the magnet and seal ring.
Info
Do not remove screws

on both sides.
K00568-10
–
Remove screw plug

with oil screen

and the O-rings.
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
K00569-10
–
Position oil screen

with the O-rings on a pin wrench.
–
Position the pin wrench through the drilled hole of the screw plug in the opposite
section of the engine case.
–
Push the oil screen all the way into the engine case.