KTM 250 EXC-F AUS 2012, Инструкции по установке

Страница: 7 / 18

SETUP
5
C00108-10
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten the screws.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.
C00110-10
–
Position the controls on the right half of the handlebar.
Info
The routing of the cables and throttle cables can be seen in the figure.
401382-01
(All EXC
‑
F models)
–
Mount the turn signal switch.
C00111-10
–
Position the controls on the left half of the handlebar.
Info
The figure shows how to route the clutch line and wiring harness.
–
Install the front fender. ( p. 9)
–
Refit the headlight mask with the headlight. ( p. 7)
–
Install the front wheel. ( p. 8)
–
Correctly mount the fuel tank breather.