12
SERVICE WORK ON THE CHASSIS
57
Warning
Danger of accidents
Reduced braking efficiency due to oil or grease on the
brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with
brake cleaner when necessary.
–
Clean and lubricate the dust boot and inside fork tube on both fork legs.
Universal oil spray (
–
Press the dust boots back into the installation position.
–
Remove excess oil.
Finishing work
–
Position the fork protector. (
–
Remove the motorcycle from the lift stand. (
12.5
Loosening the fork protector
B01515-10
–
Remove screws
1
and remove the clamp.
–
Remove screws
2
on the left fork leg. Push the fork protector downwards.
–
Remove the screws on the right fork leg. Push the fork protector downwards.
12.6
Positioning the fork protector
B01515-11
–
Position the fork protector on the left fork leg. Mount and tighten screws
1
.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
–
Position the wiring harness.
–
Position the brake line. Put the clamp on, and mount and tighten screws
2
.
–
Position the fork protector on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
12.7
Removing the fork legs
x
Preparatory work
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
101322-10
Main work
–
Remove screws
1
and take off the clamp.
–
Remove cable binder
2
.
–
Remove screws
3
and take off the brake caliper.
–
Allow the brake caliper and brake line to hang tension-free to the side.