KTM 2012 250 SX-F, Руководство по техническому обслуживанию и ремонту

Страница: 26 / 33

20
Checking the Crank Rod Bearings for Wear
Tools Needed
 8mm T-handle or socket
 10mm T-handle or socket
 30mm deep socket
 13mm hex key
 15mm deep socket
 Flathead screwdriver
Step 1: Remove the Piston
Follow all of the steps on pages 13-16 to remove the
piston. (Do not replace the piston)
Step 2: Checking for Wear
The rod will be as shown below in picture 2.3
(without the piston).
Picture 2.3 ( All Things Moto)
To check if the crank rod bearing is bad, grab the top
of the rod and try to move it up and down. If there is
Crank Rod