KTM 2009 690 Rally Factory Replica, Руководство пользователя

Страница: 69 / 104

MAINTENANCE WORK ON CHASSIS AND ENGINE
67
8.82
Checking the engine oil level
Info
The engine oil level must be checked when the engine is warm.
–
Stand the motorcycle upright on a horizontal surface.
400304-10
Condition
The engine is at operating temperature.
–
Check the engine oil level.
Info
After switching off the engine, wait one minute before checking the
level.
The engine oil reaches the top of the viewer

.
» When the engine oil does not reach the top of the viewer:
–
Add engine oil. ( p. 71)
8.83
Changing engine oil and filter, cleaning oil screens
x
–
Remove the motor guard. ( p. 59)
–
Drain the engine oil.
x
( p. 67)
–
Remove the oil filter.
x
( p. 68)
–
Clean the oil screens.
x
( p. 69)
–
Install the oil filter.
x
( p. 70)
–
Fill up with engine oil.
x
( p. 70)
–
Mount the motor guard. ( p. 59)
8.84
Draining the engine oil
x
Warning
Danger of scalding Engine oil and gear oil get very hot when the motocycle is driven.
–
Wear suitable protective clothing and gloves. If you scald yourself, hold the affected area under cold water immediately.
Warning
Environmental hazard Problem materials cause environmental damage.
–
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Info
Drain the engine oil only when the engine is warm.
–
Stand the motorcycle on its side stand on a horizontal surface.
600075-10
–
Place a suitable container under the engine.
–
Remove oil drain plug

and the seal ring.
–
Completely drain the engine oil.
–
Thoroughly clean the oil drain plug with a magnet.
–
Clean the sealing area on the engine.
–
Mount oil drain plug

with the seal ring and tighten it.
Guideline
Oil drain plug with magnet M12x1.5 20 Nm
(14.8 lbf ft)