2
SETUP
4
(250/300 EXC SIX DAYS EU, 125 EXC SIX DAYS EU)
–
Position the fork legs and tighten the screws of the triple clamp.
Guideline
Screw, top triple clamp
M8
17 Nm
(12.5 lbf ft)
Screw, bottom triple clamp
M8
12 Nm
(8.9 lbf ft)
Info
The rebound damping is located in the right fork leg (red adjust-
ing screw). The compression damping is located in the left fork leg
(white adjusting screw).
The topmost milled groove in the fork leg must be flush with the top
edge of the upper triple clamp.
Position the bleeder screws toward the front.
400223-10
–
Remove screws
1
. Remove the handlebar clamps.
–
Remove screws
2
. Remove the handlebar supports.
–
Place the handlebar supports in the required position. Mount and tighten
screws
2
.
Guideline
Screw, handlebar support
M10
40 Nm
(29.5 lbf ft)
Loctite
®
243™
Info
Position the left and right handlebar supports evenly.
600824-10
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten the screws.
Guideline
Screw, handlebar clamp
M8
20 Nm
(14.8 lbf ft)
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.
B00903-10
(All EXC models)
–
Insert the indicator lamp with the blue and brown cable colors into socket
3
.
–
Insert the indicator lamp with the blue and violet cable colors into socket
4
.
