KTM 125 EXC EU 2013, Инструкции по установке

Страница: 14 / 22

3 WORK
12
Finishing work
–
Mount the seat. ( p. 9)
3.9 Installing the front fender
B00814-10
–
Ensure that the spacers are mounted in the fender.
–
Position the front fender. Mount and tighten screws
1
.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
Info
Make sure the holding lugs engage in the start number plate.
3.10 Refitting the headlight mask with the headlight
303402-11
Main work
–
Connect the electric plug connector
1
.
B00833-11
–
Position the headlight mask and fix it with the rubber band
2
.
Info
Ensure that the holding lugs engage in the fender.
–
Position the brake line and wiring harness. Put on the clamp and mount and
tighten screw
3
.
Finishing work
–
Check the headlight setting. ( p. 12)
3.11 Checking the headlight setting
400726-10
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark a distance
B
under the first mark.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle vertically a distance
A
away from the wall.
Guideline
Distance
A
5 m (16 ft)
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the light-dark border does not meet specifications:
–
Adjust the headlight range. ( p. 13)