KTM 1090 Adventure R 2018, Инструкции по установке

Страница: 10 / 23

3 WORK
8
3.1 Installing the wind shield
A00225-10
–
Position wind shield
1
.
–
Mount and tighten screws
2
.
Guideline
Screw, wind shield M5 3.5 Nm
(2.58 lbf ft)
3.2 Removing the seat
S01782-10
–
Insert the ignition key in the seat lock 1 and turn it clock-
wise by 45 °.
–
Raise the rear of the seat, pull the seat back, and lift it off.
–
Remove the ignition key.
3.3 Mounting the seat
0 0 2 2 0 0 1 1
401677-10
–
Hook the catch
1
of the seat onto the fuel tank, lower the
rear and push it forward.
–
Insert the locking pin
2
into the lock housing and push down
the rear of the seat until the locking pin engages with an audi-
ble click.
–
Check that the seat is correctly mounted.
3.4 Recharging the battery
Warning
Risk of injury
Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and safety glasses.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks or open flames away from the battery.
–
Only charge batteries in well-ventilated rooms.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes with water for at least 15 minutes and consult a doctor immediately if battery acid and
battery gases get into the eyes.