KTI Networks KS-2260, Руководство по эксплуатации

Страница: 26 / 153

-26-
1.5.9 QoS Priority Function
This switch supports two priority levels, high and low, and provides two
priority functions:
1. Port-based Priority (Static priority)
2. 802.1p Priority (VLAN tagged priority)
Priority Classification Methods
Static priority is called port-based priority. The priority level of a receiv-
ing packet is determined by the configured priority of the input port
where the packet is received and the content of the packet is ignored.
Each port must be pre-configured with a priority level for incoming frames
or disabled setting.
802.1p Priority is a content-based priority method. If the receiving packet
is an 802.1Q VLAN tagged packet, the switch will check the 3-bit User
Priority value in TCI (Tag Control Information) field of packet tag data.
By this value, the packet is classified as high priority or low priority
according to 802.1p priority configuration. The map of priority values vs.
priority levels must be pre-configured.
The switch uses the following rules:
1. Applies Static Priority method first for tagged or untagged packets.
2. If port static priority is disabled, applies 802.1p Priority method.
3. Untagged packets are treated as low priority.
Outgoing Service Policy
The switch provides two options for outgoing service policy for high
priority packets and low priority packets.
1. High priority always first
2. Round robin method with specified [High : Low] ratio setting
This policy configuration can be set via the management interface.