4 / 7
<Adjustment the Height of Waste Oil Tray>
①
Put Oil Drainer in a stable and horizontal place.
②
Hold Waster oil Tray by hand to prevent falling down. (Pic.6)
③
Loosen Dial Nut.
Be Careful of your head not to be hit by waste Oil Tray when
loosening Dial Nut.
④
Adjust the height of Waste Oil Tray according to the position of Drain Plug.
⑤
Fasten Dial Nut securely to fix Slide Pipe.
Make sure to fix Slide Pipe and fasten Dial Nut firmly so that not to
fall.
<Receiving Waste Oil>
⑥
Confirm that the inlet valve is open. (Pic.7)
⑦
Confirm Tank Cap is loosened. ( for air release)
⑧
Confirm the position and direction of drain plug. Then loosen to remove it.
Do not poor waste oil into Tank over the stop line on Level Gauge.
Do not put oil filters, etc. on Waste Oil Tray.
INSTALLATION OF SLIDE PIPE (Pic. 4)
・
Install Slide Pipe on the front side of the Tank, and fix
it by fastening Ring Nut with a pipe wrench.
INSTALLATION OF WASTE OIL TRAY (Pic. 5)
・
Screw the bottom mouth into Slide Pipe and fix it by fastening with
a wrench. Attach Wide Hat with Falling Prevention Net to complete
Waste Oil Tray.
Apply engine oil a little on moving part of Slide Pipe if Waste Oil
Tray does not move up and down smoothly.
・
Wind up Aspiration Hose with the air hose detached, stores the Aspiration Nozzle in the holder, and keep it in
a steady place.
・
Fix the caster with the trig etc. to discharge all wasted oil of the tank, and so as not to fall and keep it when
keeping it for a long time.
A.
GOD80A Waste Oil Draining
Pic.4
Ring Nut
Pic.5
Wide Hat
Falling
Prevention
Net
Bowl
Slide Pipe
Method of custody
HOW TO USE
Pic.6
Slide Pipe
Waste Oil Tray
Tank Cap
Loosen
Tighten
Dial Nut
Direction
of
Dial Nut
Insert Valve
Pic.7
Close
Open