Quick Installation OMNI960 Series Digital Video Recorders
Revised October, 2014 2
Thank you for purchasing our product. If there is any question or request, please do not hesitate to contact your dealer. KT&C Certified Dealers can
contact KT&C directly.
DVR Pre-Installation
OMNI960 Series DVRs are highly advanced surveillance equipment that should be installed with care. Please take into consideration the following
precautionary steps before installation of the DVR.
1.
Keep all liquids away from the DVR.
2.
Install the DVR in a well-ventilated and dust-free area.
3.
Ensure environmental conditions meet factory specifications.
4.
Install a manufacturer recommended HDD.
DVR Installation
During the installation of the DVR:
1.
Use brackets for rack mounting 8/16/32 channel DVRs; for the 8/16 channel models, order optional accessory brackets KA-ORM1.
2.
Ensure there is ample room for audio and video cables.
3.
When installing cables, ensure that the bend radius of the cables are no less than five times than its diameter.
4.
Connect alarm and RS-485 cable where applicable.
5.
Allow at least 2cm (≈0.75-inch) of space between rack-mounted devices.
6.
Ensure the DVR is grounded.
7.
Environmental temperature should be within the range of -10
ºC ~ 55
ºC, 14ºF ~ 131ºF.
8.
Environmental humidity should be within the range of 10% ~ 90%.
Hard Disk Installation
Before you start:
Before installing a hard disk drive (HDD), please make sure the power is disconnected from the DVR. A factory recommended HDD should be used
for this installation.
Tools Required:
Screwdriver.
Steps
1.
Remove the cover from the DVR by unfastening the screws on the back and side.
2.
Install the HDD in the HDD rack using the provided screws. Fasten the screws on the bottom to fix the HDD.
