39
39
initialization fault
When the procedure of initialization is wrong, this
warning will occur.
40
Inverter is invalid
The inverter on button has been activated.
41
Overload
The load exceeds the system power capacity.
42
Parallel Overload
The UPS parallel system is confirmed to be overloaded
according to the set number.
43
DC component over limitation
If the DC component of the UPS output rating power is
larger than the limitation, this warning should occur
44
Bypass over current
When the bypass current exceeds the limitation, this
alarm will occur.
45
Feedback protection
This UPS is fitted with a voltage free contact closure
signal for use with an external automatic disconnect
device (by others) to protect against back-feeding
voltage into the incoming bypass supply
46
Ext. Fire Alarm
External fire detector has been activated.
47
Ext. Smoke Alarm
External smoke detector has been activated.
48
battery damaged
battery has been damaged, this warning shall occur.
49
battery over-temperature
battery over-temperature, this warning shall occur.
50
model set wrong
Model setting of the UPS is incorrect.
4.5 Options
Network Management Card with Environmental Monitoring
CAUTION!
For network management configuration and use, refer to the separate user
manual - Network Management Card with Environmental Monitor - shipped with the
CARD
.
Network Management Card replacement
SNMP card: internal SNMP / external SNMP optional
◆
Loosen the 2 torque screws (on each side of the card)
.
◆
Carefully pull out the card. Reverse the procedure for re-installation
The slot called SNMP supports the MEGAtec protocol. We advise that NetAgent II-3 port is
also a tool to remotely monitor and manage any UPS system
