Drg No. KSR98123-IS-A
KSR Lighting Ltd, Unit E Hazleton Interchange, Lakesmere Road, Horndean, Hampshire, PO8 9JU
14.04.2020MAC
Installation Sheet
KSR98123
Read these instructions before commencing installation. Please give these instructions to the owner/occupier after
installation to retain for future reference/maintainence.
Navara HB
Available finish: Black
IP65 Dimming Microwave Sensor
IP65
220-240VAC~50/60Hz
KSR Lighting Aftersales: 023 92 674343
E-mail: [email protected]
These fittings are Class II and do not require to be Earthed
Important Information
It is recommended that these controls are installed and fitted by a qualified electrician
ensuring the installation complies with current IEE wiring regulations & local building
control. These products are designed for connection to a 220-240V~50/60Hz supply.
Any faulty, broken or damaged sensors should be replaced immediately.
KSR will not accept responsibility for any claims arising from a poor installation.
Please Note: The limited warranty shall be deemed null and void in the following circumstances: Failure by the installer, end user or any third
party to exercise caution to protect any covered product or part from outside damage, adverse temperature, humidity conditions, fluctuations in
the electrical system or physical abuse as well as failure related to workmanship in the installation of the products or parts.
Important User Advice
Always switch off mains supply before fitting or servicing.
Do not use Megger or similar high voltage instruments. Due to the fact this control contains electronic components that maybe damaged by
high test voltages, they must be disconnected from the circuit before testing.
To prevent damage to the control, do not mix with conventional magnetic ballasts on the same electrical circuit.
At the end of life the luminaire is classed as WEEE under directive 2014/30/EU and should be disposed of in accordance with local legislation.
Installation Procedure
KSR recommends that you familiarise yourself with the installation. Once you are completely satisfied:
Safely isolate the mains supply.
Locate the area's suitable to install this control on the luminaire (See KSR98120, KSR98121 or KSR98122 for further information).
Avoid the following situations:
Avoid pointing the detector towards objects with highly reflective surfaces, such as mirrors etc.
Avoid metal objects in the line of sight.
Avoid pointing the detector towards objects that may move in the wind, such as curtains, tall plants etc
Install the sensor on to the luminaire.
Connect the wiring as per the instructions supplied with the highbay. If you do not have these please contact KSR for a copy or download from
www.ksrlighting.com
See overleaf for setting options, never remove the cover or adjust the dip switches without safely isolating the mains supply.
Switch on the power and test.
Sensor Specification
:
Mains Input - 220~240VAC 50/60Hz
Lux Control - 2, 10, 50 or 2000 Lux
Hold Time - 5s, 30s, 90s, 3min, 5min, 10min, 20min
or 30min
Rated Load - LED 1000W
Halogen 2000W
Detection Area - 360°
Detection Range - 50% or 100%
Detection Radius - 10m Max (<24°C)
Stand-by Period - 0s, 10s, 1min, 5min, 10min, 30min,
60min or
∞
Stand-by Dimming Level - 10%, 20%, 30% or 50%
Parasitic Power - 0.5W
Installation Height - 4m~15m
Detection Speed: 0.6~1.5m/s
Working Temperature: -20~+40°C
4-15m
10m
10m
59mm
72mm
78mm
700mm
