sirena da esterno imago - imago outdoor siren
16
Connection clamps
Table 1: Universal version imago™
The inputs are controller with OC outputs normally open or closed (Start with negative/
negative missing), or with a power relay that give or cut a 12V voltage (Start with negative/
positive missing). During the start up, an auto‐learning stage has to be set to establish the
default values.
Table 2: KS-BUS version imago™
START UP Procedure
The correct powering procedure of
imago
siren must initially to be done through the
battery (6V. 1,2Ah Dimensions: 98x50x22 mm‐not included) and then giving power (13,8
Vdc typical) coming from the Control Panel. It is fundamental to respect this order.
Once powered, the siren will give just a single flash from its main power LED and the buzzer
will sound for a second to verify the correct functioning of all parts ; moreover the red
signaling LEDs will keep flashing (slow at 1 Hz) until the siren will remain open (tamper
switches open). After closing the cover, the LEDs will flash faster (2 Hz) for 20 sec. If the
siren has been powered also from the Control Panel, then the power LED will start to flash
(period 300/700ms) for 20 sec.; the siren will acquire the inputs stand‐by condition and
start its full functioning. In case you still need to connect the power to the Control Panel,
the siren will go in "low consumption mode" waiting for the external power.
CLAMP
TYPE
DESCRIPTION
[F]
Output
Failure warning (faulty battery or internal electronic
check)
[TAMP]
Output
Normally closed Link (NC) to warn about the opening
of the siren
[LI]
Input
Activation of the two auxiliary warning LEDs
(operable from an output OC or with a positive)
[BL]
Input
Activation of the only power LED (blinking) (operable
from an output OC or with a positive)
[AL]
Input
Activation of the acoustic and optical warning
(operable from an output OC or with a positive)
‐+
Power Supply
Power supply clamps 13.8V
[A][B]
KS‐BUS
Ksenia bus terminals
‐+
Power Supply
Power supply clamps 13.8V
