2
Meganorm
5. Introduction
KSB has supplied you with equipment that has been
designed and manufactured with the most advanced
technology. Due to its simple and tough construction it will
not need much maintenance. With the aim of providing our
clients with a satisfactory, trouble free operation, we
recommend to install and care our equipment according to
the instructions contained in this service manual.
This manual has been prepared to inform the end user
about the construction and operation of our pumps,
describing the adequate procedures for handling and
maintenance. We recommend that this manual should be
handled by the maintenance supervision.
This equipment should be used in the operational
conditions for which it was selected as to: flow rate, total
head, speed, voltage, frequency, and temperature of
pumped liquid
Fig. 1 –Nameplate
For requests about the product, or when ordering spare
parts, please indicate the type of pump and the Production
Order nº (serial nº). This information can be obtained from
the nameplate on the actual pump. If the nameplate is not
available, the PO nº is engraved in low relief on the suction
flange, and on the discharge flange you may find the
impeller diameter
.
Attention
:
This manual contains very important
instructions and recommendations. Its careful reading
is an obligation before installation, electrical
connections, first starting and maintenance.
Contents
Denomination Chapter
Denomination Chapter
Application
1
Installation
9
Design
2
Operation
10
Designation
3
Maintenance
11
Operating data
4
Explode view/Parts list
12
Introduction
5
Recommended spare parts
13
Technical data
6
Special recommendations
14
Transportation
7
Pressure limit x Maximum temperature
15
Preservation and storage of idle pumps
8
Wearing areas maintenance
16
Place for description
of manufacturer data.
Place for order number
Place for description
of type and size of
the pump.
