13
3. HOT WATER FUNCTION
Warning:
In certain cases, steam may come
out of the nozzle before any hot water is
obtained.
• Fill the water tank (b).
• Press the control “on/off” control «
» (e2),
and its indicator light will flash.
• Turn the tap (i1) to the «
» position.
• Place the container under the nozzle (i2)
(8)
.
If necessary, adjust the height of the grille
support
(4)
. The tip must not touch the
bottom of the container so as not to
obstruct the passage of the water.
As soon as the appliance reaches the right
temperature, the indicator light of the control
(e2) stops flashing.
• Press the «
» control (e5).
• Turn the function selector (d) to the «
»
position.
• Once the quantity of water required is
obtained, turn the function selector (d) to
the «
» position.
Notes :
• After using the hot water function, press the
«
» control (e5) to deactivate this function.
The appliance will cool itself down
automatically until it reaches the correct
temperature to return to the espresso
function.
• If you do not press the «
» control (e5)
within about 2 minutes after using the hot
water function, the appliance will cool itself
down automatically to return to the espresso
function.
4. PROGRAMMING CUP FILL
This function allows you to programme the
quantity of coffee you want for each of the
espressos prepared.
The appliance is preprogrammed for a
quantity of 50 ml per cup.
This programming is to be done while an
espresso is being made.
• Prepare the appliance to make one or 2
cups of espresso (see paragraph “Espresso
function”).
As soon as the appliance reaches the right
temperature, the indicator light of the control
«
» (e2) stops flashing.
• Press the “
memo
” control (e3). Its indicator
light will flash.
• Hold down the control (e6) «
» or the
control (e7) «
» until you obtain the
desired quantity of espresso.
• Press again on the “
memo
” control (e3) to
store this quantity of coffee in memory and
to end the programming procedure.
If you do not press the “
memo
” control (e3)
within 10 seconds, programming stops
automatically and the changes are not
recorded.
Maintenance
•
Unplug the appliance and allow it to cool.
•
Never wash the accessories for your espresso
in the dishwasher.
• Clean the body of the appliance with a
damp cloth.
After use, the water tank must be emptied.
. The drip tray (l)
•
Each time an espresso is prepared, the drip
tray fills with water. This is perfectly normal.
If there is any water in the fill indicator (l1)
you must then empty the drip tray.
•
Remove the grille and its support
(11)
and
empty the drip tray (l).
•
If necessary, clean the drip tray, the grille
and its support with water and a little non-
abrasive dish detergent, rinse and dry.
When reassembling, put back the plastic
block situated at the back of the tray
(12)
.
. The percolation head and the filter
holder
Please note :
These may be burning hot.
These must be cleaned after every use. All
you need to do is run a damp cloth over the
percolation head and clean the other
accessories with water and a little non-
abrasive dish detergent. Rinse and dry.
• If the percolation head becomes heavily
encrusted, unscrew its grille using a coin,
clean it and replace it, tightening it firmly
(13)
.
• If the filter holder becomes heavily
encrusted, unscrew its grille using a coin,
clean it and replace it, tightening it firmly
(14)
.
