Krups F 897, Руководство пользователя

Страница: 15 / 50

15
• Never immerse the appliance in water.
•
Keep out of reach of children and do not
allow the cord to hang down.
•
Follow the descaling instructions.
•
Do not use the appliance if it is damaged or
if the cord is in poor condition.
•
If the cord or any other specific part
becomes defective, these must be replaced
by a Krups approved service centre. You
should never, under any circumstances, open
the appliance yourself.
•
Check that the capsule holder is firmly in
place before making coffee.
Accessories
For best results, the appliance is delivered with
a set of accessories.
•
4 Nespresso cups
•
4 varieties of Nespresso coffee (4x10
capsules)
• 1 special hexagonal key (for dismantling the
capsule holder)
• 1 cleaning needle
For further information on the different
varieties of coffee available, or to order
capsules, you should contact your Nespresso
Club. Details on your appliance or in the «
Welcome Pack ».
Setting-up the appliance
•
Lift the water tank lid and remove the water
tank
(1) .
•
Fill the water tank with fresh water (2) .
Maximum capacity is
1.8 l = about 25 espresso cups.
• Replace the water tank and press down
firmly into position, so that the lower valve
opens
(3) .
•
Close the lid again.
For a good cup of espresso, it is
recommended tha you observe the following
points:
• Empty the water tank after use.
• Change the water every day.
•
Do not use mineral water or distilled water.
• Clean the water tank at least once a week.
Before using your espresso
maker for the first time
• Plug in the appliance.
•
Introduce the empty capsule holder into the
fixing ring : to do this, position the handle at
about 90
°
to the left, then thighten up by
pulling the handle firmly to the right (4) .
§
Fill the water tank.
•
Place a container, large enough, under the
capsule holder and another under the steam
nozzle
(5) .
•
Turn the steam/hot water button to the
position
(6) .
• Press the ON/OFF key , the red operating
indicator light will flash and all the green
indicator lights will come on
(7) .
Once the red operating indicator light stops
flashing the appliance is ready to be used
(8) .
• By pressing the key , the water will run
through the system (9) .
• Repeat this operation five times.
• Press the and turn the steam/hot water
button to the position (10) . Allow about
half a litre of water to run through and then
turn the steam/hot water button to the
position.
Preparation of Espresso
•
Fill the water tank (1) (2) (3) .
• Preheat the capsule holder, put it in position
on the machine, but without the capsule
(4) .
•
Turn the steam/hot water button to the
position
(6) .
•
Press the ON/OFF key , the red operating
light will flash and all the green indicator
lights will come on
(7) . Once the red
operating light stops flashing the machine is
ready for use
(8) .
ART. 897.PM6.5 18/02/04, 10:10 15
Downloaded from CoffeeMachineManual.com Manuals