23
Getting started
To successfully enjoy the full benefits of your
new Krups espresso maker, please carefully
read these instructions in their entirety before
using this product.
• Place your espresso maker on a stable, heat
resistant surface away from water splashes
and sources of heat such as, an electrical
heating plate or near a flame.
• Ensure the drip tray and drip tray grid are in
place when using the machine.
Starting the appliance and setting the
time:
Your XP2070 combined espresso-filter coffee
maker has a central screen (S) making it easy
to use and providing a wide range of settings.
When you plug in your appliance for the first
time or after an extended power cut, you can
set the clock in European (24-hour clock) or
American (AM-PM) display mode.
You will
not be able to access the functions of the
appliance without setting the time.
• When the appliance is switched on, the
pictograms
, and
blink. Select
the display mode by pressing the scroll
button (S1) and confirm your selection by
pressing the OK button (S2).
• Once the display mode has been confirmed,
you are then prompted to set the time. The
2 “hour” digits blink. Press the scroll button
(S1) and confirm your selection by pressing
the OK button (S2). The 2 “minutes” digits
blink. Set the minutes by pressing (S1) and
then (S2) to confirm.
• The hour and the minutes can be set either
by pressing the button in succession or by
holding down the button and scrolling down
(button S1).
• To change the time setting, hold down the
button (S1) (>2 s) and proceed as above by
pressing (S1) and (S2) in succession.
• To set the automatic start time for your
coffee maker, see the FILTER COFFEE section.
Espresso
Before using your machine for the first time,
clean the system completely as follows:
• Open the lid and lift out the water container
using the handle
(1)
. Fill the water container
with fresh, cold water
(2)
.
• Place the water container back into the
machine by positioning it firmly in the water
container compartment
(3)
and close the lid.
• Turn on the machine
(4)
. The start/stop
switch (N) will blink. The appliance is ready
as soon as this blinking stops.
• Your espresso maker is equipped with
three filters designed for 1 cup, or for 2
cups of espresso using ground coffee, or
for E.S.E. (Easy Serving Espresso) pods.
The first comes in the filter holder (I),
the other two are found in the
appliance’s transport packaging.
• Choose the filter that you wish to use and
place it in the filter holder
(5)
. Store the 2
others in the espresso lid (A).
• Then place the filter holder under the
appliance’s brewing head. To ensure that the
filter holder is in the correct position, turn
the handle so it points to the left at a 45
degree angle
(6)
, place the filter holder flat
against the brewing head, then turn the
handle towards the right
(7)
as far as it can
go.
• Place a container, as large as possible,
beneath the filter holder
(8)
.
The machine is ready to operate.
• By pressing twice on the espresso selection
button (O) so as to select the 2-cup mode
(10)
, the water will flow through the
pipes of the appliance.
Repeat this process five times.
To start the coffee maker part, see the FILTER
COFFEE section.
Using the various functions of
your espresso maker
1. MAKING ESPRESSO
The appliance will pre-brew the coffee before
making each cup in order to bring out the full
flavour for a satisfying cup of coffee. The
pump will work for 3 seconds, stop for 3
seconds, then continue with the cycle until
the end of the process.
XP2070 anglais.P65
7/11/05, 12:32
23
