Krups 896, Руководство пользователя

Страница: 15 / 38

15
day in order to quickly rinse the system and
thus avoid particles of coffee sticking
together. Then put the capsule in position.
• Remove the capsule holder then place the
capsule upside down in the capsule holder
(11) ; each one contains a single dose of
fresh coffee for a cup of espresso.
•
Replace the capsule holder and press until
the handle is facing you or very slightly
offset to the left
(12) .
•
Place the pre-heated cup (see “Preheating
cups”) under the “coffee” outlet.
• Set the function selector to position « »
(13) .
•
Once the espresso is finished, reset the
function selector to « », remove the
capsule holder and throw away the used
capsule
(14) .
• To ensure that your next espresso is prepared
at the optimum temperature, replace the
empty capsule holder to retain its heat.
Preparing hot water
•
Fill the water tank with fresh water.
• Turn the function selector to « », switch
on the appliance and place the hot water/
steam selector to position .
• After the yellow temperature indicator light
has gone out, immerse the steam nozzle
into a container which you are holding
vertically.
•
Turn the function selector to position « »
(15) . Once there is enough water in the
container, reset it to « ». Next turn the
steam nozzle towards the interior, above the
grid, so that the drips fall into the tray.
Take care: the steam nozzle is burning
hot.
Making steam
Steam makes the milk frothy for a cappuc-
cino, and also preheats cups or any kind of
liquid; the noise you hear during this
operation is caused by the intermittent
running of the water pump.
Please note :
Before making steam, make sure that the
capsule holder on the machine is empty to
prevent the coffee becoming dried out and
blocking the hole in the coffee outlet.
Frothing milk for a cappuccino
You can make the milk frothy in order to whip
up a cappuccino. For best results, use the
accessory specially designed for this purpose.
Fit it onto the steam / hot water nozzle
(16) .
Please note:
This accessory must only be used for this
purpose.
•
Pour about 100 ml of skimmed milk into a
small high-sided container (maximum
capacity 0.5 L) which will fit beneath the
steam nozzle; the container must also be
chilled (do not rinse it in hot water before
use).
•
First prepare an espresso, but only fill the
cup halfway.
•
Remove the used capsule and replace the
empty capsule holder. Set the hot water /
steam selector to position «
» (17) .
•
When the yellow temperature indicator light
goes out, dip the the steam nozzle in the
container holding the milk in such a way
that its end is completely immersed in the
milk.
•
Turn the function selector to position « »
(18) . During preparation, do not move the
container and make sure that the nozzle
does not touch the bottom, as this would
prevent steam from escaping. Once the
operation is finished, turn the function
selector to position « ».
•
Remove the container and turn the function
selector just for a second to position « » in
order to eliminate the residue of the milk
which might remain in the end of the
nozzle.
• Remove the “ cappuccino ” accessory from
the steam / hot water nozzle and clean it
(see “ Maintenance ” section). Clean the
nozzle immediately with a damp sponge.
NESPRESSO.896.EUR 21/01/04, 13:29 15