Krups 896, Руководство пользователя

Страница: 14 / 38

14
(hotplate for cups, capsule holder, steam
nozzle).
•
Never immerse the appliance in water.
•
Keep out of reach of children and do not
allow the cord to hang down.
• Follow the descaling instructions.
•
Do not use the machine if it has been
damaged or if the cord is in poor condition.
• If the cord or any other specific element
becomes defective, these must be replaced
only by an approved KRUPS service centre.
You should never under any circumstances
open the appliance yourself.
• Check that the capsule holder is firmly in
place before making coffee and reset the
selector to « » before loosening the
capsule holder.
Accessories
For best results, the appliance is delivered with
a set of accessories:
•
4 cups
•
4 varieties of Nespresso coffee (4 x 10
capsules)
•
1 special hexagonal key (for dismantling the
capsule holder)
• cleaning needle
For further information on the different
varieties of coffee available, or to order
capsules, you should contact your Nespresso
Club.
Setting-up the appliance
•
Raise the lid of the water tank and remove
the water tank to fill it
(1) (2) .
Maximum capacity 1.8 L, which is about 26
cups of espresso.
•
Replace the water tank and press down
firmly so that the lower valve opens. Close
the lid again
(3) (4) .
For a good cup of coffee, it is recommended
that you observe the following points:
•
Empty the water tank after use.
• Change the water daily.
•
Do not use mineral water or distilled water.
•
Clean the water tank at least once a week.
Before using your espresso
maker for the first time
• Plug in the appliance.
•
Rinse the heating system thoroughly by
running through one or two tanks of fresh
water (without a capsule or capsule holder).
•
Introduce the empty capsule holder into the
fixing ring: to do this, position the handle at
about 90° to the left then turn
(5) .
Once in place with a capsule, the handle
should be facing you or very slightly offset to
the left.
• Place a container, as large as possible, under
the capsule holder and another under the
steam/ hot water outlet. The function
selector must be in position « »
(6) .
•
Engage the on/off switch (7) . The thermos-
tat indicator light (yellow) will come on.
•
Once the yellow light goes out (which
means the machine is hot), set the hot
water/ steam selector to position « ».
Allow half a water tank to run through via
the coffee outlet by turning the function
selector to position «
» (8) ; then set it to
position « ». The remainder of the water
will thus rinse the steam/ hot water circuit
(9) .
Preparing an espresso
•
Fill the water tank with fresh water.
•
To preheat the capsule holder, leave it in
place in the fixing ring (but empty, with no
capsule)
•
Turn the function selector to « ». Switch
on the appliance
(10) . Wait until the
temperature indicator light (yellow) has gone
out.
We recommend turning the function selector
to position «
» for about 5 seconds before e
the first coffee and after the last coffee of the
NESPRESSO.896.EUR 21/01/04, 13:29 14