Kruger&Matz DJ-002, Руководство пользователя, Страница: 34 / 88

34
Owner’s manual
English
• If a monitoring system is available, connect the amplifier of the monitoring
system to the RCA output BOOTH.
1. For sound recordings, connect a recording unit to the recording output REC.
The recording level is independent of the position of the output controls
MASTER CONTROL, MASTER LEVEL and BOOTH VOLUME.
2. Instead of the audio signal coming from the computer, the master outputs
and the booth output can also supply the signal of an external signal source
with line level output (e.g, CD player). Use the stereo RCA jacks LINE
INPUT for connecting the unit.
2. CONNECTING A COMPUTER
1. Set the power selector switch to the position USB for power supply via the
USB connection of the computer.
2. Use the supplied USB cable to connect the controller to an available USB
port on your computer. As soon as the controller is connected to a computer,
it will be recognized as a generic USB audio device and the required drivers
are installed. The power indicator lights up red to indicate that the controller
is receiving power from the USB. The controller can be used in conjunction
with your computer's soundcard without causing conflicts. You may connect
and disconnect the controller at any time.
3. The controller is supplied with power via the USB connection of the
computer. However, if the connection should not supply sufficient power
(e.g. when connected to a non-powered USB hub), use the supplied power
unit: Connect the cable of the power unit to the power input DC IN 5 V/1 A
and the power unit to a power outlet. Set the power selector switch to the
position ADAPTOR. Use the unit only with the supplied power unit. Always
disconnect the mains connector when you wish to change connections,
move the unit to a different place or if it is not used for a longer period.
4. After connecting, start the DJ software Virtual DJ LE. If the program has
already been started prior to the connection, it must be terminated and
restarted, otherwise the controller cannot be operated.
3. CONFIGURATION OF THE CONTROLLER
1. Call the software's configuration menu with the button CONFIG and
configure the program for operation with this device in the tab Sound Setup.