OPENING WIDTH - 3”
1
3
9.
M E A S U R E A N D C U T T R A C K S
1
2
3
4
Measure your opening width at the track centerline.
Determine your track length:
TRACK LENGTH = OPENING WIDTH – 3”
Before cutting the track,
- Ensure springs are clear of cut zones and end caps and loose nuts are removed.
- Align track base and cover flush on one end.
- Tightly wrap the assembly with a short strip of painters tape to prevent sliding.
- Trim-cut one end for optimal alignment.
Now make your mark and cut track to length.
1
With the track upside-down, position one hex nut in the black
polymer track protector as shown and insert into the bottom
channel of the track base. Attach the door stop kit as shown
and slide assembly towards center of track.
Note the correct position and orientation of the hardware
shown.
Install a second hex nut behind in the channel following the
installed track protector. Repeat this process for the other end
of the track.
Cap the ends of the track by attaching the track end caps
using a 1/16” allen wrench and the provided screws.
10.
T R A C K P R E A S S E M B LY
2
3
Door stop screw
Door stop
Door stop hex nut
Track protector
Second hex nut
Track end cap
End cap screws
