Krowne Metal Corporation
• 100 Haul Rd. Wayne, NJ 07470
P: (800) 631-0442 • F: (973) 872-1129
krowne.com
2
Modular Bar Die Installation
Specifications
• Bar die structure fabricated out of 16 gauge galvanized steel with stainless steel finish on bartender side to hide drains and plumbing
• Supports 1,000 pounds per foot of downward force
• No legs required. Units attached to bar die structure for quick and easy cleaning
• Chaseways built into structure to conceal all soda, beer, electrical and plumbing lines. Makes a more appealing bar
• Built-in electrical outlets installed per customer’s request (quantity and location to be verified)
• Units pre-assembled at factory and shipped in sections up to 7’ in length for easy installation (cuts installation costs)
• Bar die structure can easily be installed and sealed to floor to prevent seepage from bartender side to customer side
• Bar top and front panels can be easily installed to structure
• End panels (by millwork) easily removed for access to soda, beer, electrical and plumbing lines for future service or repair
• Can be upgraded to stainless steel
General Specifications
Structure:
Configured to the exact size and shape of underbar
equipment, freestanding cabinets and openings, as specified.
Chase:
Interior chase runs the entire length of the structure
including corners.
Millwork:
Done by outside contractors
Mechanical Specifications
Utility lines:
Dedicated chase locations for hot/cold water supply
lines, beverage line conduits, and electrical conduit (behind the
underbar equipment) this chase is accessible from the floor and
runs the entire length of the bar.
Floor drains:
Locate floor drains directly below workboard
equipment. The number of floor drains will vary depending on the
bar layout and local codes.
Millwork:
Done by outside contractors
Plumbing Specifications
All water service and waste connections can be made from the
front of the bar (decorative front panel removed). Local codes
dictate installation (by others)
.
Utility Specifications
A 5-1/2” open zone is furnished behind the equipment to
provide room for trunk lines, soda lines, plumbing, electrical,
etc. To travel vertically or horizontally within the bar structure.
Connections can be made from the front of the bar with panels
removed.
Electrical Specifications
All electrical requirements such as receptacle to blenders,
washers, coolers, soda guns, light, etc. (by others).
ADVANTAGES
SPECIFICATIONS
• Phillips head screw driver
• Level
• Tape measure
• Chalk line
• Power drill
• Shims for leveling
• 7/16 ratchet wrench
• 7/16 box wrench or adjustable wrench
• 1/4” x 7/16 hex head bolts and nuts (used for
adjoining modular bar sections to each other).
• #8 Self starting galvanized screws (used for
modular front panels & Anchoring to floor).
Fasteners
are supplied in a
plastic bag with your bar die.
Make sure all screws are
facing the same direction
when adjoining modular
sections for maintenance
purposes.
For proper installation, it is important to have the following tools on
hand before starting the installation.
TOOLS REQUIRED
