Krown Portaview PV20, Инструкция по эксплуатации

Страница: 8 / 16

7
1: If the cell phone vibrates, you have an incoming call. Connect
your PV20JR using the cable that came with your TDD to the
cell phone.
2: Answer the call with your cell phone (usually you press
çTALKé or çSENDé button on your cell phone, refer to your
cell phone manual for how to answer a call.)
3: Turn on your PV20JR and type your greeting message.
When you are ready to hang up, turn off your PV20JR and press the
button to hang up the call for your cell phone using the çhang upé
or çdisconnecté button.
* Connecting your TDD to a wireless phone is an optional feature. Please call
a Krown representative to have it installed.
USING YOUR PV20JR WITH A CORDLESS PHONE
You can connect your PV20JR to a cordless phone with a 2.5mm
headset jack, and enjoy the freedom of making a call around the
house. Charge your TDD and cordless phone fully before use.
MAKING A CORDLESS CALL WITH YOUR TDD:
1: Connect the PV20JR to the cordless phone using the 2.5mm
audio cable. (provided by Krown Mfg.)
2: Turn on your TDD
3: Press çoné button on your cordless phone and watch the
çPHONEé light illuminate on your TDD to make sure you get
a dial tone.
4: Dial the phone number as you would normally on your
cordless phone.
5: If the other TDD or Relay Agent picks up your call, Your
PV20JR will display text message and the communication link
has begun.
TROUBLESHOOTING FOR TTY/TDD-WIRELESS CALL
There are many new technologies that have been used to establish
the wireless communication link between users. It is possible to
have errors in any phone conversation. Below are some tips to
assist with any questions that you may have.
çGarbled texté
It maybe caused by lost, damaged, or late signals sent through the
air to the receiver. It happens with any wireless call, even with
non-TTY calls, and mainly caused by nature.
Move your TDD and the cell phone to where you receive strong
and consistent signal.
If you use a cordless phone, refer to your ownerês manual to know
how to switch channels or move closer to the base to strengthen the
signal. Check to make sure that you have a good connection from
the cable to the TDD and the wireless phone.
çDropped callsé
This happens when you are moving between 2 cell towers or in
valleys, hills, and tunnels. Try to redial when you have a stronger
signal from your cell phone.
(This is common when traveling, or having a weak signal)
çFeedbacké
If your çPHONEé light on your TDD is constantly on, your
PV20JR is getting possible feedback. Reduce the volume of your
cell phone or cordless phone until the receiving messages are clear.
8
"ON"
"PHONE"
"disconnect"
"hang up"
"Garbled text"
owner's
"PHONE"
"Dropped calls"
"Feedback"
"TALK" or "SEND"