- 54 -
Set the radio channel on control panel of the external radio.
Set the radio channel, there are eight channels to choose from
Set the radio power, if the working distance is not far, and
interference is low, you can choose the low power transmitting
If the radio is successfully transmitted, the TX indicator will flash
at intervals
§3.2.3 Mounting the Rover Station
After verifying the successful transmitting of the base station, you can
start the erection of the rover station. The steps are as follows:
1) set the receiver to the rover station radio mode;
2) Power on the rover station mainframe, fix it on the centering rod of
the carbon fiber pole, and screw on the UHF differential antenna;
3 Install the handheld bracket and the handheld controller
Содержание 300
