Krone BiG Pack 870 HDP XC, Оригинальная инструкция по эксплуатации

Страница: 205 / 410

Settings 15
Checking/setting the twine pusher relative to the channel slot 15.10
BiG Pack 870 HDP XC
Original Operating Instructions 150000760_00_en 205
Checking the twine bars
„
Trigger the tying process manually with machine at standstill, refer to page 110 .
„ Turn the flywheel manually in working direction until the lower needle (1) (needle yoke) is
just in front of the twine driver (2),
refer to page 111 .
„
Apply flywheel brake refer to page 89 .
„ Pull the linch pin and swivel up the knotter.
„
By turning the twine pusher, swivel the twine bar (3) to the middle of the knotter needle (1)
and check dimension X.
Æ If the dimension is X=2-4 mm , the setting is correct.
Æ
If the dimension is not X=2-4 mm , the twine pusher must be set.
„ Repeat this process for all twine pushers (1).
Setting the twine bars
„ Loosen the nut (4).
„
Move the twine pusher (3) until the dimension is X=2–4 mm .
„
Tighten the nuts (4).
„
Swing the knotter down and secure with the linch pin.
„
Repeat this process for all twine pushers (1).
„ Release flywheel brake, refer to page 89 .
„
Finish the tying process manually, refer to page 111 .
„ Apply flywheel brake refer to page 89 .
„
Tension the twine pusher shaft, refer to page 207 .
„
Check/set twine pusher relative to the channel slot, refer to page 205 .
„
Check the overreach of the twine pusher at second knot, refer to page 206 .
15.10 Checking/setting the twine pusher relative to the channel slot
BPG000-050
„
Disconnect machine from tractor, refer to page 190 .
„
Apply flywheel brake refer to page 89 .
„ Check if the knotter gearbox is in idle position, refer to page 111 .