Krone 1 000 245, Оригинальная инструкция по эксплуатации, Страница: 74 / 108

Settings
74
11.3 Setting the Rotor Inclination
The rotor pitch angle has been set at a transverse angle to the chassis in the factory. If the
crops are not picked up properly, the working quality can be improved by adjusting the rotor
pitch.
The rotor pitch angle is adjusted for each rotor via the guide wheels at the chassis. The best
results are achieved if the rotor pitch adjustment ensures the tines are closer to the ground level
when outputting the crops than at the start when picking up the crops.
• Shut down and safeguard the machine, see chapter Safety -> Safety routines, "Shutting
down and safeguarding the machine".
11.3.1 Rotor chassis (serial)
SW700077_2
I
II
+
1
Fig. 39
Longitudinal inclination
The longitudinal inclination (rotor tilts forwards) changes when the rear guide wheels (right and
left) of the running gear are inserted into one of the seven boreholes in the hole pattern.
Pos. I = reduce rotor inclination
Pos. II = increase rotor inclination
Do not step under the raised rotors.
• Only raise the outrigger arms as far as necessary to perform the changeover work.
• To set rotor inclination, dismount the rear guide wheels and move them in the hole pattern.
For better orientation, observe the basic setting of rotor inclination, refer to chapter Initial
Operation, “Rotor Inclination - Basic Setting”.
Transversal inclination
The transversal inclination (in the direction of travel) changes when one of the rear guide
wheels is set higher or lower than the other guide wheel.
Vernier adjustment via eccentric cam (1):
−
= Reducing rotor inclination
+ = Increasing rotor inclination
Do not step under the raised rotors.
• Raise the outrigger arms only as far as necessary to perform the changeover work.
• Loosen the nut on the wheel bolt.
• Turn the eccentric (1) to set the rotor inclination.
• Tighten the nut on the wheel bolt to a tightening torque of M
A
=200 Nm.