KROHNE OPTISWITCH 5100 C, Руководство пользователя

Страница: 20 / 40

20
6 Setup
OPTISWITCH 5100 C, 5150 C • Contactless electronic switch
30428-EN-210701
6 Setup
6.1 General information
The figures in brackets refer to the following illustrations.
With plastic housings, the switching condition of the electronics can
be checked when the housing cover is closed (control lamp). With the
basic setting, products with a density ≥ 0.7 g/cm³ (0.025 lbs/in³) can
be detected. For products with lower density, the switch must be set
to ≥ 0.5 g/cm³ (0.018 lbs/in³).
On the electronics module you will find the following display and
adjustment elements:
•
Signal lamp (1)
•
DIL switch for mode adjustment - A/B (2)
•
DIL switch for adjustment of the density range (3)
Note:
Always immerse the tuning fork of OPTISWITCH 5100 C, 5150 C in
a liquid to test its function. Do not test the function of OPTISWITCH
5100 C, 5150 C with your hand. This can damage the sensor.
6.2 Adjustment elements
1
2
1
2
3
Fig. 11: Oscillator SWE60C - Contactless electronic switch
1 Control lamp (LED)
2 DIL switch for mode adjustment
3 DIL switch for adjustment of the density range
Control lamp for indication of the switching status
•
Green = Output closed
•
Red = Output open
•
red (flashing) = failure
With the mode adjustment (A/B) you can change the switching
condition of the relay. You can set the required mode according to the
Function/Configuration
Signal lamp (1)
Mode adjustment (2)