KRK Rokit 5 G2, Руководство пользователя

Страница: 15 / 20

14
The sound quality changes...
The monitor hisses, hums or makes other loud noises...
• Repeat the steps in the Troubleshooting section above before continuing to the next
steps.
• Disconnect the signal cable at the input of the monitor. With power on, place your ear
close to each driver (tweeter/woofer) and listen for noise (i.e. a slight hiss or hum).
If there’s absolutely no sound whatsoever, it could be that one or more of the drivers
(woofer, tweeter or both) is at fault. It’s also possible that the problem lies somewhere
in the electronics.
• Play some non-distorted source material at a low volume. Carefully cover the tweeter
(to block the sound) without touching the diaphragm. Is the woofer producing a clean
sound? If there is not a clear tonal quality, or any sound at all, then the woofer
probably needs to be replaced.
• Cover the woofer so you can hear mostly the tweeter. Is the tweeter producing a clear
sound? If there is not a clear tonal quality, or any sound at all, then the tweeter
probably needs to be replaced.
• Once you have a better idea of what may be at fault please call our customer service de
partment. We will help you determine the best solution to correct your monitors. KRK
Customer Service can be reached at 1-800-444-2766, or by email at Service@Gibson.com.
Here are some suggestions that will help you eliminate these undesirables from your
system:
• Make sure that the power cord is plugged snugly into the IEC socket on the rear
of the monitor.
• Check the connections between the signal source and the monitor. The RoKit G2’s XLR
and TRS connectors are a completely balanced system. If you’re connecting an unbal
anced output to the monitor, be sure that you’re using Pin 2 for signal and have Pin 1
and Pin 3 tied together at the source end.
• Refer to the Connecting Your System section on page 6 of this manual to ensure
that the AC mains is matched to the operating voltage requirements.
• All audio equipment should use the same ground point. Check all other devices
using the same AC output in the building such as dimmers, neon signs, TV screens, and
computer monitors. These devices should not be using the same circuit.
rokit_manual REV E_rokit_manual 2/19/13 10:24 AM Page 15