KRK Expose E8, Руководство пользователя

Страница: 7 / 16

C) hF level Adjust
This is a seven-position switch that adjusts the tweet-
er level through its entire frequency spectrum. The
adjustments are in .5 dB steps and include the follow-
ing gain se1.0, +0.5, 0, -0.5, -1.0, -1.5, -2.0. It
is recommended to set this control to 0 and listen
carefully before adjusting to your preferences.
D) lF Adjust
This is a low frequency boundary adjustment switch designed to optimize linear bandwidth
in your environment. This switch compensates for proximity to wall areas that may create
undesirable increases in bass response and, in the process, create non-linearity of the
E8B’s overall performance. This switch enables you to adjust/compensate for this situation
and retrieve the full linear bandwidth produced by the loudspeaker. The LF adjust has 3
positions with the “A” setting providing the most bass response. Please refer to the LF
Adjust frequency chart for more information.
E) Voltage Select Switch for AC Mains
This switch provides four voltage options that your E8B loudspeaker will operate within. The
loudspeaker will operate at 100V, 120V (North America), 230V, and 240V (Europe). If you
operate in a 230V environment, please use the 240V setting. This switch is tied to the
adjacent fuse compartment. If you are operating in a 100V or 120V environment, please
use a fuse rated at 6-amperes. For operation in a 230V or 240V environment, please use
a fuse with a 3.15-ampere rating.
Connecting your System
Before powering your monitors on, please take a moment to ensure the Voltage Select
Switch for the AC Mains is set to match your location. At this point, all connections should
be made, all faders and controls should be set to their minimum levels, and all other
equipment should be powered on prior to powering on your Exposé E8B monitors.
The power On/Off switch is located on the rear panel and is internationally marked to
indicate the operational status. ( — ) = ON and ( O ) = OFF. An LED illuminates the KRK
Logo on the front baffle when power is applied.
Balanced XLR Connector
The Exposé E8B monitors use a single
balanced XLR 3-pin connector for the input
signal. This connector is configured in the
following manner…
• Pin 1: Ground
• Pin 2:
Hot / (+)
• Pin 3: Cold / (-)
7