Krigsvoll GeBe POWERMAN 3000i, Руководство пользователя, Страница: 31 / 36

30 31
English English
4. Remove the screws, and remove the cover
5. Drain the fuel from the carburetor by loosening
the drain screw on the carburetor float chamber.
6. Turn the 3 in 1 switch to “OFF”.
7. Tighten the drain screw.
8. Install the cover and tighten the screws.
9. Turn the fuel tank cap air vent knob to “OFF” after
the engine has completely cooled down.
ENGINE
Perform the following steps to protect the cylinder,
piston ring, etc. from corrosion.
1. Remove the spark plug; pour about one table-
spoon of SAE 10W-30 into the spark plug hole and
reinstall the spark plug.
2. Recoil start the engine by turning over several
times (with 3 in 1 switch knob off) to coat the
cylinder walls with oil.
3. Pull the recoil starter until you feel compression.
(This prevents the cylinder and valves from rusting).
4. Then stop pulling.
5. Clean the outside of engine and spay antirust
additive.
6.Store the generator in a dry, well-ventilated place,
with the cover placed over it.
7. Lay the engine vertically.
TROUBLESHOOTING
ENGINE CAN’T START LØSNING
Fuel systems No fuel in the fuel tank - add fuel. If there is fuel in
the tank, clean fuel filter
Tett bensinfilter Rengjør og skift om nødvendig
Tett dyse i forgasser Rengjør og skift om nødvendig
Oil level is low Add engine oil
Poor spark Spark plug dirty with carbon or wet. Remove carbon
or wipe spark plug dry. Faulty ignition system, consult
an autorized dealer
NÅR AGGREGATET IKKE GIR STRØM LØSNING
Safety device (DC protector) to “OFF” Press the DC protector to “ON”
The AC pilot light (green) go off Stop the engine, and then restart.
PARAMETERS
Model PM3000i
GENERATOR
Generator type
Inverter
Rated frequency 50 Hz
Rated voltage 230V
Max. output power 2,5 kW
Rated output power 2,3 kW
Power factor 1,0
AC output quality ISO8528 G2
THD ≤5 %
Noise Level (3/4 load) 64,7 dB/Lpa
DC Output 12 V – 8,3 A
Overload DC – Non-fuse Protector
AC - Control by inverter
overload protect program
Engine
Engine modell
Loncin 165F-4
Engine type Single cylinder, 4-Stroke,
forced air cooling, OHV
Displacement 149 cm³
Fuel type Unleaded Gasoline
Fuel capacity 4.0 liter
Continue Running Time
(at rated power)
Ca. 2,7 hours
Oil Tank Capacity 0,6 liter
Spark Model No. F7RTC
Starting mode Recoil start
Length×Width×Height 565x339x467 mm
Net weight 27 kg