Stand Februar 2016
Seite 2
©
Krick Modelltechnik Knittlingen
of this instruction book. Before you start build-
ing you should identify all wooden parts and
mark the part nos. on the part with a soft pen-
cil. During the building process you should
carefully cut out the needed parts only at their
bars with a sharp knife.
Starting this hobby is much easier, if you have
any modeller near you, even we have tried to
solve all critical steps in this design. A more or
less experienced modeller can help you best
with problems and can obtain that your first
model “Lisa M.” will become a success.
Ask a ship model club in your area or your
local hobby shop, where you did buy this kit.
We wish you good fun and success with build-
ing this nice model
I. BOAT STAND and HULL
1. Boat stand
First build the boat stand with parts 2, 3 and 4.
After the glue is dry carefully sand and varnish
the stand several times. As you will later place
your wet model on the stand, it is important to
have this water resitant. As an apolster you
can use some pieces of foam tape on the up-
per sides which will contact the hull.
2. Hull
Mark the positions of the rudder tube and of
the prop shaft on the hull (1). First measure the
center line of the hull and mark. Then mark the
rudder tube position 35 mm from the stern of
the hull. Mark the position of the prop shaft 15
mm down from keel end.
Now drill the holes for prop shaft and rudder
tube.
First use a small drill of about 2 – 3 mm and
then enlarge to the correct size – rudder tube 4
mm and prop shaft tube 7 mm. You can do this
best with a round file that the hull does not
split.
3. Deck
Now prepare the fit of the deck (5) inside the
hull. At the areas of the bow it is needed to
sand the deck with an angle. The deck should
ly down without any force.
Now place the deck into the hull and mark a
line on the sides 2 to 3 mm over deck level.
Cut the hull down only until to this line with a
sharp knife or strong scissors.
Now place strips (6 to 9) on the underside of
the deck around the inner cut out. Place a
weight on the deck until the glue is dry, that the
deck cannot twist.
2
3
4
4
1
5
5
1
chamfer in the front
area
