cuit. Ask your installer for advice.
ො If the power cord is damaged, in order to avoid risks, it should be replaced by the man-
ufacturer, maintenance department or similar sector professionals.
ො This appliance is not intended to be operated by means of an external timer or separate
remote-control system.
ො Only the appropriate connector must be used.
ො Do not use attachments not recommended or supplied for this product.
ො Disconnect the appliance from the power supply if it is left unattended and before as-
sembling, disassembling or cleaning.
ො When the hairdryer is used in a bathroom, unplug it after use since the proximity of
water presents a hazard even when the hairdryer is switched off.
ො Always unplug the hairdryer after use.
ො Do not use or store the hairdryer where it can come into contact with water.
ො If the appliance falls into water, UNPLUG IT IMMEDIATELY. Do not reach into the water
until the power has been disconnected.
ො This hairdryer should never be left unattended when plugged in.
ො Do not pull or wrap power cord around the hairdryer.
ො Keep the cord away form heated surfaces.
ො Never block the air vents at the rear of the hairdryer, or place it on a soft surface where
the air vents free of dust, hair, etc. Do not insert any objects into the air vents.
ො Do not direct hot air toward the eyes.
ො The attachments may get hot when using the device. Be careful when handling them.
ො Do not put the hairdryer down while it is operating.
ො Do not use the hairdryer in humid or damp conditions. Do not allow the appliance to
get wet, i.e. dripping or splashing, as this may be dangerous.
2. HOW TO USE
ASSEMBLY
Clip the concentrator onto the front of the hairdryer (if required).
Before switching on, unwind the power cable and plug into the mains socket and set to
the on (I) position. When you have finished, set the switch to the off (0) position.
