KRESS KUH10, Оригинальное руководство пользователя

Страница: 11 / 80

11
EN
OPERATING
INSTRUCTIONS
Note: Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for cutting, roughing and
brushing metal and stone materials without using water.
For cutting metal, a special protection guard for cutting
(accessory) must be used.
ASSEMBLY AND
OPERATION
ACTION FIGURE
BEFORE OPERATION
Removing the battery pack See Fig. A1
Charging the battery pack See Fig. A2
Installing the battery pack
WARNING: When replacing
the battery pack, do not
insert the battery until the
Grinding/Cutting Disc comes to
a complete stop!
See Fig. A3
ASSEMBLY
Assembling Auxiliary Handle See Fig. B
Assembling Grinding/Cutting Disc
See Fig. C1,
C2, C3
Adjusting Wheel Guard
Note: Before any work on the
machine itself, remove the
battery pack. For work with
grinding or cutting discs, the
protection guard must be
mounted. Use the correct type
of disc for your application. If
the power tool is intended to
perform cutting off operations, a
guard specific for this operation
must be fitted.
The coded projection on the wheel
guard ensures that only a guard
that fits the machine type can be
mounted.
Open the clamping lever. Place the
wheel guard with coded projection
into the coded groove on the spindle
of the machine head and rotate
to the required position (working
position).
To fasten the wheel guard, close the
clamping lever.
The closed side of the wheel
guard must always point to the
operator.
See Fig. D
OPERATION
Using On/Off Switch See Fig. E
Variable Speed Control See Fig. F
Hand Grip Areas See Fig. G
Rough Grinding
Warning! Never use a
cutting disc for roughing.
WORKING HINTS FOR
YOUR ANGLE GRINDER
1. Always start at no load to achieve maximum speed
then start working.
2. Do not force the disc to work faster, reducing the
Disc’s moving speed means longer working time.
3. Always work with a 15-30 angle between disc and
workpiece. Larger angles will cut ridges into the
workpiece and affect the surface finish. Move the
angle grinder across and back and forth over the
workpiece.
4. When using a cutting disc never change the cutting
angle otherwise you will stall the disc and angle
grinder motor or break the disc. When cutting, only
cut in the opposite direction to the disc rotation. If
you cut in the same direction as the disc rotation
the disc may push itself out of the cut slot.
5. When cutting very hard material best results can be
achieved with a diamond disc.
6. When using a diamond disc it will become very
hot. If this happens you will see a full ring of sparks
around the rotating disc. Stop cutting and allow to
cool at no load speed for 2-3 minutes.
7. Always ensure the workpiece is firmly held or
clamped to prevent movement.
MAINTENANCE
Remove the battery before carrying out any
adjustment, servicing or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.