KRESS KU230, Руководство пользователя

Страница: 13 / 28

13
LED indication
The LED will be lit when the switch is
pressed.The tool and battery are equipped
with automatic power-off protection system.
The LED flickers for 3 seconds and then
goes off, indicating that the protection
system works. At this time, the system
automatically cuts off the power supply
to prolong the battery life. The following
situations may trigger automatic power-off
protection:
• Overload: Tools are overloaded when
they are running, the current is too
high. In this case, release the switch, stop the
operation leading to tool overload, and restart
the switch.
• Overheat: In the case above, if the tool
is not started, the tool and battery may be
overheated. In this case, cool the tool and
battery pack before starting the switch again.
• Low voltage: The tool does not work
when the remaining capacity is too
low. In this case, dismantle and replace the
battery pack.
Warning: Make sure the reversing
lever is on the left or right, press the
switch and the LED light comes on.
See Figure F
FAQS
1. Why has the switch been pressed and the
machine does not work?
There is a reversing lever at the top of the switch. When it is
in the middle position, the machine will lock the start-stop
switch. Put it where it needs to be turned and press the
button, the machine will start to rotate.
2. Why does the electric drill stop running before
the screw is tightened?
At this time, please adjust the torsion adjustment ring
between the frame and the chuck. The torsion correspond-
ing to position 1 is the smallest, and that corresponding to
position 20 is the largest. Position specially for drilling
holes This problem can be solved by adjusting the torsion
adjustment ring to a higher level.
3. Why is the working time of the same battery
pack sometimes long and sometimes short?
As mentioned above, if a battery pack is left unused for too
long, its working time will be shortened. Such situation will
be improved after charging and using for several times. Un-
der doing heavy work, such as screwing big screw into hard
wood, the battery power will be consumed very fast. Do not
charge in the environment below 0 or above 40°C, which
will also affect the performance of the battery pack.
MAINTENANCE
Be sure to pull out the battery before any repair
work on the machine.
No additional lubrication or special maintenance is needed
for your power tool. Do not use water or chemical detergent
to clean your power tool. Wipe it with a dry cloth. Tools
should be kept in dry environment and keep the motor vent
clean. Try not to use it in dusty environment.