KRESS HAMMER DRILL, Оригинальное руководство пользователя

Страница: 19 / 176

Operation English 19
BH-EN / 0907
EN
Mechanical gear selection
(option)
The gear selection / rotation stop switch III can be
used to select three settings.
The switchover can best be performed at standstill.
Please note that the gear selection / rotation stop
switch
III can only be turned 1 level at a time. After
the On/Off switch V has been actuated and the ma-
chine has started, the gearbox switches to the
preselected setting. Only then can the gear selec-
tion / rotation stop switch
III be turned to the next
setting.
Selecting the direction of rotation
Operate the rotational direction switch VII only
when the machine is at a standstill!
Set the required direction of rotation.
Important : Press the rotational direction switch VII
up to the stop on the housing, i. e. until it snaps in
audibly.
If the rotational direction switch
VII is set between
the positions "R” and "L”, the machine cannot be
switched on.
The operational mode switch II can be used to se-
lect the required settings.
The switchover can be performed best at standstill.
After the On/Off switch
V has been actuated and
the machine has started, the gearbox switches to
the preselected setting.
Impact drilling
Drilling / Stirring
Adjusting the chisel
The chisel can now be turned by hand to the re-
quired working position.
The chisel latches automatically as soon as it is ra-
dially loaded by the working or chiselling process.
Chiselling
1 Low speed range: Hammer drilling,
drilling with normal twist drills in
wood/metal over 8 mm, and stirring
tasks
2 High speed range: Drilling with nor-
mal twist drills up to 8 mm
No rotational motion: Light chisel
work
Clockwise rotation :
For drilling and fixing screws.
Anticlockwise rotation :
For loosening and removing screws
and nuts.
Selecting the modes of operation
Impact drilling
-NOTE-
Left rotation when impact drilling damages the drill.
Switch off the impact mechanism for diamond
crown drilling or for mixing work.
When hammer drilling, only use drills with tungsten
carbide inserts and SDS-Plus shafts.
The use of commercially available rock drills with
cylindrical shafts by means of the adapter
6 and a
normal drill chuck in conjunction with the pneumat-
ic impact mechanism is not possible.
Drilling / Stirring
Positioning the chisel
-NOTE-
In devices where the selection of the above symbol
is not available, put the operational mode switch in
an intermediate position.
Chiselling
-NOTE-
In some devices, the gear selector/rotation stop
switch
III must be used at this point. Please take
note of the enclosed illustrations.
37231_BA_Bohrhammer_West.book Seite 19 Montag, 13. Juli 2009 7:55 07