
KREMLIN
Page 2
Manual : 573.156.112
Read paint and solvent manufacturer's technical instructions.
Spraying of some materials may result in hazardous working conditions. To protect the operator,
respirator mask, hand cream and glasses are required (Refer to chapter "Safety equipment" of
KREMLIN selection guide).
EQUIPMENT REQUIREMENTS
The operating pressure of these equipments are aprticularly high. Consequently, some precautions
must be taken in order to prevent from accidents and from unsafe working conditions.
Â
Never exceed the components maximum working pressure of the equipment.
HOSES
Do not use hoses with a maximum burst-proof pressure less than four times the maximum service
pressure of the pump (see data sheet).
Be certain the hoses are not crimped, leaking and not unrolled.
Be certain hoses are in good condition and showing no evidence of damage.
Â
Use only air hose with static conductor to supply the spray gun.
All fittings must be tight and in good condition.
GUN
Never wipe the end of the tip with fingers.
Never point the spray gun at anyone or at any part of the body.
Always depressurize air and hoses before carrying out any servicing on the gun.
MAINTENANCE REQUIREMENTS
Â
Never modify these equipments.
Check them daily, keep them in a good condition and replace the worn parts
only with KREMLIN
parts.
Before cleaning or removing components of the equipment, it is compulsory :
-
to stop the gun by shutting off the compressed air supply,
-
to trigger the gun to depressurize the hoses.
3. TECHNICAL
FEATURES
Small, lightweight decorating spray gun with exceptional manoeuvrability.
J 53 P
J 53 A
Maximum air feeding pressure
6 bar / 87 psi
Recommended air working pressure
3 bar / 43.5 psi
Maximum fluid feeding pressure
6 bar / 87 psi
(suction cup)
Maximum operating temperature
50°C / 122°F
Weight with cup
470 g / 1.03 lb
470 g / 1.03 lb (without cup)
Nozzle and needle
Stainless steel
Gun body
Aluminium
Air fitting
M 1/4 NPS (+ M 1/4 BSP)
Fluid fitting
M 1/4 NPS