KRAUSMANN U98020-00B, Руководство по эксплуатации

Страница: 18 / 24

18
U98020-00B KRAUSMANN POWER TOOLS
English | EN
pressure will not increase efficiency, and may
damage your appliance.
O nly use the battery charger in closed rooms
and do not expose this to rain or humidity.
Do not use a battery charger whose power
lead is damaged. It must be replaced by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Ιn the event of damage being apparent
to the battery charger housing, have this
examinded by a specialised repair shop and
if necessary replaced.
W hen the charger is in use it MUST be super-
vised, if there is any evidence of overheating
then IMMEDIATELY disconnect the charger
from the power supply.
I f gas or smoke is emitted from the battery
during charging switch off the power supply
and move to a well vented area. CAUTION: If
there is liquid leaking from the battery wear
protective clothing, glasses and clothes as
this can be acidic.
Always wear protective eyewear and ear pro-
tectors when working. A dust mask should be
worn during any dust-producing work.
Do not disassemble or modify the battery. It
contains safety and protection devices, which,
if damaged, may cause the battery to gen-
erate heat, explode or ignite. The protection
circuit module provided with battery packs is
not to be used as a substitute for a shut-off
switch.
Do not place the tool in or near fire, on stoves
or other high temperature locations.
Do not place the tool in microwave ovens,
high-pressure containers or on induction
cookware.
I f you intend to store the tool for a period
without use then store it at room tempera-
ture (19°C to 25°C), charge to about 30-50%
of capacity. When storing for very long
periods boost-charge the battery once a year
to prevent over discharge.
Do not continue charging the battery if
it does not recharge within the specified
charging time. Doing so may cause the bat-
tery to become hot, explode or ignite.
Insert the plug on the charging unit into
a power socket and turn the power on if
required.
Insert the battery with the charging output
interface to the charging port. The charging
time depends on the capacity of the battery
and the type of the charger.
The process of charging battery pack is red,
yellow and green light in turn. When the red
light stays lit, the battery pack has less power.
When red and yellow lights stays lit, the bat-
tery pack has more than half of power. When
red, yellow and green light is on, the battery
pack is fully charged.
SAVE THESE INSTRUCTIONS
WARNING:
Misuse or failure to follow the safety rules stated in this
instruction manual may cause serious personal injury.
4. Functional description
and specifications
Intended use
3
Before using your tool
Be sure to read the following information before
you use your cordless screwdriver for the first
time:
Charge the battery pack with the charger
supplied.
Only ever use screwdriver bits which are
suitable for the purpose and in faultless
condition.
Always check for concealed electric cables
and gas and water pipes when drilling and
screwing in walls.
1
2
Place the battery pack and charger on a flat
non-flammable surface and away from flammable
material when re-charging the battery pack.
Charging the battery
The tool is intended for hammer drilling in
concrete, brick and stone as well as for light
chiseling work. It is also suitable for drilling without
impact in wood, metal, ceramic and plastic.
Featuring electronic control and right / left rotation
option, it is also suitable for screw driving and
thread cutting.