KRAUSMANN SDS-PLUS 9851, Руководство по эксплуатации

Страница: 15 / 20

15
KRAUSMANN POWER TOOLS 9851
English | EN
WARNING:
I f the replacement of the supply cord is necessary, this has
to be done by a professional in order to avoid a safety
hazard.
Power supply
Power input
No load speed
Impact rate
Impact energy per
stroke
Chuck
Drilling capacity in
Concrete
Steel
Wood
Cable length
Weight
230V~50Hz
900W
800/min-1
3200/min-1
3.5J
SDS-plus
26mm
13mm
40mm
2m
4.2kg
Tool 9851
Switching ON and OFF
Overload clutch
Mode selector switch
To start the tool,press the ON/OFF 1 switch
and keep it depressed (fig 1). To switch off
the tool, release the ON/OFF 1 switch. For low
temperatures, the tool reaches the full hammer
/ impact capacity only after a certain time. This
start-up time can be shortened by striking the drill
/ chisel against the floor one time.
If the tool insert becomes caught or jammed, the
drive to the drill spindle is interrupted. Because
of the forces that occur, always hold the power
tool firmly with both hands and provide for a
secure stance. If the tool jams, switch the tool
OFF and loosen the tool insert. When switching
the tool ON with the drilling tool jammed, high
reaction torques can occur!
Operate the mode selector switch only when
the tool is at a standstill. This will help prevent
premature wear of the tool.
WARNING:
B efore plugging in the tool, always check to see that the
switch trigger actuates properly and returns to the OFF
position when released.
WARNING:
A s soon as the power tool jams, switch the tool off
immediately. This will help prevent premature wear of
the tool.
1
fig 1
For drilling in concrete, masonry etc., rotate the
mode selector switch 3 so that the pointer points
to the symbol . Rotate the mode selector switch
2 so that it points to the symbol (fig 2). Use a
tungsten-carbide tipped bit.
Hammer drilling
3
2
fig 2
For chipping, scaling or demolition operations,
rotate the mode selector switch 3 so that the
pointer points to the symbol . Rotate the mode
selector switch 2 so that it points to the symbol
(fig 3). Use a chisel of your preference 9 (bull point
or cold chisel).
Chiseling