KRAUSMANN 7000, Руководство по эксплуатации

Страница: 8 / 22

8
Charging the battery
The battery is protected from exhaustive discharge. An integrated protective circuit automatical -
ly switches off the tool when the battery is flat. In this case the bit chuck will cease to turn.
WARNING:
Do not press the ON/OFF switch anymore if the protective circuit has actuated.
This may damage the battery.
CAUTION:
The handle may become a little warm during the charging process. This is normal.
To charge the tool, connect the USB charging cable 6 to the charging socket on the base
of the screwdriver handle and the other end of the cable to a USB socket.
T he indicator light will illuminate to indicate that the battery is charging. When charging
is complete (indicator light will be green), unplug the charger from the power supply
and the tool.
If the battery pack fails to charge, please check whether there is voltage at the socket-outlet and
check for proper contact with the charging contacts in the battery charger.
T imely recharging of the battery pack will help it serve you well for a long time. You must
recharge the battery pack when you notice that the power of the screwdriver drops.
N ever allow the battery pack to become fully discharged. This will cause it to develop a defect.
WARNING:
When battery charge runs out after continuous use or exposure to direct sunlight
or heat, allow time for the tool to cool down before re-charging to achieve the full charge.
Power supply
Rotation speed
Chuck
Max. torque Battery
Charging time
Weight 3.7V DC
250 rpm
¼” hex
3 Nm
1500mAh, Li-Ion
~ 2-3 hours
350 gr
Tool 7000
WARNING:
Do not operate for long periods at low speed because excess heat will be
produced internally.
Switching ON and OFF
To switch the tool on, press and hold the ON / OFF switch 1 . To turn the tool off, release the
ON / OFF switch 1 .