KRAMER: SIMPLE CREATIVE TECHNOLOGY
Using the WP-220 XGA/Audio/Video Line Driver
6
5.1 Installing the WP-220 XGA/Audio/Video Line Driver
To install your
WP-220
XGA/Audio/Video Line Driver
:
1. Connect the 5 BNC output connectors (each is color-coded: red (R), green
(G), blue (B), yellow (Vertical Sync), and white (Horizontal Sync)) to the
pre-installed wiring in the wall box opening that connects to the XGA
acceptor (for example, a projector).
2. Connect the balanced line / PC audio out terminal block connectors (for
example, to power amplifiers) as one of the following:
Figure 6: Connect to a Balanced Acceptor
Figure 7: Connect to an Unbalanced Acceptor
3. Connect your 12V DC power supply to the
POWER
pins
1
, taking care that
polarity is correct
.
4. Connect the wires of the coax cable to the VIDEO OUT pins
2
, taking care
that
polarity is correct
.
5. Insert the
WP-220
directly into the wall box opening, and then mount the
front panel securely using the screws.
1 Connect the wire labeled “+” to the +12V pin, and the wire labeled “–” to the GND pin
2 Connect the composite video wire to the VIDEO pin, and the Ground wire to the GND pin (see Figure 8)
