14
VS-84HN - Operating the VS-84HN 8x4 HDMI Matrix Switcher
To store a preset (for example, to preset 10):
1. Configure the switching as required for the preset (for example, Input 4 to
Output 3).
2. Press the STO button.
The STO button flashes.
3. Select an OUT or IN SELECT button to store the device setting (for example,
IN 6 for preset 10).
4. Press the STO button to store the current setup.
You have to press the STO button within 10 seconds or the procedure automatically
times out.
To recall a preset (for example, preset 10):
1. Press the RCL button.
The RCL button flashes.
2. Press the relevant OUT or IN button that stored the preset (for example, IN
6/preset 10).
3. Press the RCL button to recall the stored preset.
The RCL button stops flashing.
6.4
Resetting the IP Parameters
This procedure resets only the IP related parameters. All switching and
preset values remain unchanged.
To reset the IP parameters to their default values (see
Section
Press and hold the ETH Reset button on the rear panel while powering up
the device
i
im Vertrieb von CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
