Connecting the VS-81SP 8 x 1 Loudspeaker Switcher
7
7
6
Connecting the VS-81SP 8 x 1 Loudspeaker Switcher
To connect the
VS-81SP
, as shown in
Figure 2
, do the following
1
1. Connect the input source (for example, the speaker outputs from a power
amplifier) to the OUT/IN terminal block connectors.
:
2. Connect the IN/OUT connectors to the speaker pairs (up to eight).
3. As an option you can connect a PC and/or controller to the:
•
RS-232 port (see section
6.1
)
•
RS-485 port (see section
6.2
)
4. Set the DIP-switches (see section
6.3
).
5. If required, connect remote contact-closure switches to the REMOTE
terminal block connector (see section
6.4
).
6. Connect the power cord to the power socket and connect the power cord to
the mains electricity.
Note
: In a reverse configuration (see
Figure 3
), you can connect up to eight
power amplifiers to the IN/OUT input connectors and one speaker pair to
the OUT/IN output connector.
1 Switch OFF the power on each device before connecting it to your
VS-81SP
. After connecting your
VS-81SP
, switch on its
power and then switch on the power on each device