KRAMER: SIMPLE CREATIVE TECHNOLOGY
Understanding the VP-727
18
3
.
Pressing the Chessboard
button and then the TAKE
button causes the transition to
occur. The PROGRAM INPUT
button 2 illuminates to
correspond with the PREVIEW
INPUT button 2. The RGBS
source is displayed on both the
PREVIEW and PROGRAM
screens:
2
. During the presentation, the
HD Component source is
outputted via the DVI PROGRAM
OUT connector. Before changing
to the RGBS source, the
demonstrator previews how that
source currently looks on his local
display:
The PROGRAM INPUT button 3 and
the PREVIEW INPUT button 2
illuminate:
1
. In this example an RGBS source is connected to input 2, and an HD
Component
input 3. Set the OSD Settings as follows
source is connected to
:
Figure 8: Example showing the use of the PREVIEW and PROGRAM Output
The transition can occur in one of two modes
1
:
The Follow mode (shown in Figure 8) in which the PROGRAM input
button is switched to the same position as the PREVIEW input button after
the TAKE button is pressed
The Swap mode, in which the PREVIEW input buttons and the PROGRAM
input buttons switch places after pressing the TAKE button. For example, in
Figure 8 the PROGRAM input button 3 would switch to 2 and the
PREVIEW input button 2 would switch to 3, so the RGB source is
displayed on the PROGRAM screen and the HD Component source is
displayed on the PREVIEW screen.
1 As selected via the Transition OSD Menu, see section 9.1.2