Connecting the RGBH / Balanced Audio Matrix Switcher
29
7. Click the
Port Settings
button. The Port Settings dialog box appears.
Figure 29 shows the Port Settings dialog box and Table 6 describes its
settings.
8. Check
Raw Mode
.
Figure 29: Port Settings Window
9. Click
OK
.
10. Click the
Save
button (see Figure 26).
11. Click the
Close
button (see Figure 26).
Table 6: Port Settings Description
Setting
Description
Timeout Reconnect If checked, the Com Port Redirector re-establishes the connection if the connection
times out
1
Server Reconnect If checked, the Com Port Redirector re-establishes the connection if the server closes it
1
Inband Listen
If checked, the Com Port Redirector uses the inband redirector protocol on inbound
connections from a VP-88ETH. This protocol allows settings like modem signals, baud
rate and parity to be exchanged between Com Port Redirector and the server.
Connection
Timeout
Specifies the maximum number of seconds that the Com Port Redirector waits for a
connection to be made before giving up on this attempt. If Timeout Reconnect is
enabled, each connection attempt lasts this long. If Timeout Reconnect is disabled, the
connection attempt fails after this interval and no more attempts are made.
Force v2 Protocol
N/A
No Net Close
If checked, prevents the network connection from being dropped when the
communications application is closed. To drop the connection, click the Disconnect
button in the Com Port Redirector Configuration window. This allows applications to
close and reopen ports, without waiting for the network connection to be reestablished
and negotiated.
1
When auto-reconnecting, the Com Port Redirector tries to reconnect until the connection succeeds or you click the Cancel
button in the pop-up connection dialog box. If the port was closed by the communications application or by clicking
Disconnect, the Com Port Redirector does not try to auto-reconnect