#
Feature
Function
14
AUDIO OUT 5-pin Terminal
Block Connector
Connect to a balanced or unbalanced stereo audio acceptor.
15
S/PDIF digital audio output
Connect to a digital audio acceptor.
16
IR 3.5mm Mini Jack
Connect to an IR Sensor (in) or Emitter (out) to control a remote device.
17
Ethernet RJ-45 Connector
Connect via a LAN to a PC to control the
VP-427UHD
and/or extend Ethernet signals to the
HDBT transmitter via the HDBT IN port.
18
RS-232 Terminal Block
Connector
Connects to a controller to control the
VP-427UHD
or to extend RS-232 signals between the
VP-427UHD
and the RS-232 port of the connected HDBT transmitter.
19
12V DC
+12V DC connector for powering the unit.
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
Step 3: Install the VP-427UHD
Install
VP-427UHD
using one of the following methods:
•
Attach the rubber feet and place the unit on a flat surface.
•
Fasten a bracket (included) on each side of the unit and attach it to a flat surface.
www.kramerav.com/downloads/VP-427UHD
•
Mount the unit in a rack using the recommended rack adapter
www.kramerav.com/product/VP-427UHD
Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your
VP-427UHD
. For best results, we recommend that
you always use Kramer high-performance cables to connect AV equipment to the
VP-427UHD
.
For optimum range and performance use the recommended Kramer cables available at
www.kramerav.com/product/VP-427UHD
Connect AUDIO OUT
To a balanced stereo
audio acceptor:
To an
unbalanced
stereo audio
acceptor:
Step 5: Connect the power
Connect the 12V DC power supply to
VP-427UHD
into the mains electricity. When the connected transmitter provides PoE for the
VP-427UHD
, you do not need to connect it to the 12V DC power supply.
Safety Instructions
Caution:
There are no operator serviceable parts inside the unit.
Warning:
Use only the power cord that is supplied with the unit.
Warning:
Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.
Warning:
Disconnect the power and unplug the unit from the wall before installing.
for updated safety information
Step 6: Operate the VP-427UHD
Operate the
VP-427UHD
:
•
Toggle the HDBT/HDMI front panel
button to select the input.
•
Control device via OSD menu or remotely
by RS-232 serial commands or Ethernet
transmitted by a touch screen system,
PC, or other serial controller.
•
Control remote devices on the
transmitter via RS-232, IR or Ethernet
signal extension.
RS-232 Control / Protocol 3000?
Baud Rate:
115,200
Parity:
None
Stop Bits:
1
Data Bits:
8
Command Format:
ASCII
Example: (get device model): #MODEL?<CR>
Default Ethernet Parameters
IP Address:
192.168.1.39
UDP Port #:
50000
Gateway:
0.0.0.0.
Subnet mask: 255.255.0.0
TCP Port #:
5000
