KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VP-23N Presentation Switcher
12
6 Connecting the VP-23N Presentation Switcher
This section describes how to:
Connect the rear panel (see section 6.1)
Wire the CAT5 connector (see section 6.2)
Connect a PC or other controller via the RS-232 port (see section 6.3)
Connect a controller via the RS-485 port (see section 6.4)
Control the VP-23N via the ETHERNET (see section 6.5)
Cascade several machines (see section 6.6)
Set the dipswitches (see section 6.7)
6.1 Connecting the VP-23N Rear Panel
In Figure 4, the audio connections are not shown, except for the microphone
and speakers connections.
In this example, all the outputs are connected to the same projector. Use the
projector controller to switch between the
VP-23N
video outputs
1
.
To connect
2
the
VP-23N
, as illustrated in Figure 4, do the following
3
:
1. Connect the following video sources:
One
4
composite video source (for example, a composite video player)
to the CV IN 1 BNC connector
One
4
s-Video source (for example, an s-Video player) to the Y/C IN 1
4p connector
One
4
VGA/UXGA source (for example, a computer graphics source)
to the UXGA IN 1 HD15F connector
1 Or projector inputs
2 You do not need to connect all the inputs
3 Switch OFF the power on each device before connecting it to your VP-23N. After connecting your VP-23N, switch on its
power and then switch on the power on each device. Switching on the VP-23N, recalls the previous setup from the non-
volatile memory
4 Although in this example only one source is connected, you can connect all of the four inputs, that is, 12 in total
