Kramer VP-108, Руководство пользователя

Страница: 7 / 18

Your VP-108 1:8 XGA / Balanced Stereo Audio DA
5
Table 1: VP-108 1:8 XGA / Balanced Stereo Audio DA Features
# Feature Function
1 POWER Switch Illuminated switch for turning the unit ON or OFF
2 AUDIO INPUT Terminal Block
Connector
Connect to the balanced stereo audio source
3 XGA INPUT 15-pin HD Connector Connect to the XGA source
4 LEFT LEVEL Trimmer Adjust
1
the left output signal level
5 RIGHT LEVEL Trimmer Adjust
1
the right output signal level
6 LOOP 15-pin HD Connector For looping to increase output availability
7 OUTPUT Terminal Block Connectors Connect to the balanced stereo audio acceptors (from 1 to 8)
8 OUTPUT 15-pin HD Connectors Connect to the XGA acceptors (from 1 to 8)
9 REMOTE Terminal Block Connectors Connect to the contact closure switches
10 RS-485 Connector RS-485 detachable terminal block port
11 RS-232 9-pin D-sub Connector Connect to PC or other Serial Controller
12 SETUP Dipswitches Dipswitches for setup of the unit
13 Power Connector with Fuse AC connector enabling power supply to the unit
Figure 2 and Table 2 define the underside controls:
Figure 2: VP-108 Underside
Table 2: VP-108 Underside Features
Feature Function
ID BIT Switch Set to ON position
2
to select the ID BIT
3
TERMINATION
4
Switch
Set to ON position
2
to terminate with 75 , or move to Hi-Z for looping
EQ .
4
Trimmers Adjust
1
the cable compensation equalization levels for blue, green and red
LEVEL
4
Trimmers Adjust
1
the output signal levels for blue, green and red
1 Insert a screwdriver into the small hole and carefully rotate it
2 The factory default
3 Sometimes notebook computers refuse to output a VGA signal to an external VGA monitor if they do not detect the ID BIT
as ON. Set the ID BIT to ON using this switch so that the notebook will output to an external VGA monitor
4 Separately for Blue (B), Green (G) and Red (R)