Connecting the VM-50CA
7
6 Connecting the VM-50CA
To connect a
VM-50CA
unit as the example in Figure 3 illustrates, do the
following
1
:
1. Connect a component video source (for example, an HDTV satellite receiver)
to the Y, Pb/Cb, and Pr/Cr IN RCA connectors, and to the S/PDIF INPUT
RCA connector.
2. Connect
2
the:
Y, Pb/Cb, and Pr/Cr OUT 1 RCA connectors to the component video
acceptor (for example, a plasma display), and the digital audio
S/PDIF
3
OUT 1 RCA connector to an AV-Receiver
Y, Pb/Cb, and Pr/Cr OUT 5 RCA connectors and the digital audio
S/PDIF
3
OUT 5 RCA connector to a home theater system
3. Connect the power cord (not shown in Figure 3)
4
.
4. If required, adjust
5
the audio level, the Y, Pb/Cb, and/or Pr/Cr output
signal level, and/or the Y, Pb/Cb, and/or Pr/Cr cable compensation
equalization level.
1 Switch OFF the power on each device before connecting it to your VM-50CA. After connecting your VM-50CA, switch on
its power and then switch on the power on each device
2 You can connect the component video and audio outputs to up to five component video and audio acceptors. When less than
five outputs are required, connect only those outputs of the VM-50CA that are required, and leave the other outputs
unconnected
3 Alternatively, or in addition, connect the ANALOG AUDIO RCA connectors (not shown in Figure 3)
4 We recommend that you use only the power cord that is supplied with this machine
5 Insert a screwdriver into the small hole and carefully rotate it, trimming the level
