Kramer Electronics Ltd.
VP-440
– Protocol 3000
42
Protocol 3000
The
VP-440
Presentation Switcher/Scaler
can be operated using the Kramer Protocol 3000
serial commands. The command framing varies according to how you interface with
VP-440
.
Generally, a basic video input switching command that routes a layer 1 video signal to HDMI
out 1 from HDMI input 2 (
ROUTE 1,1,2
), is entered as follows:
•
Terminal communication software, such as Hercules:
The framing of the command varies according to the terminal communication software.
•
K-Touch Builder (Kramer software):
•
K-Config (Kramer configuration software):
All the examples provided in this section are based on using the K-Config software.
You can enter commands directly using terminal communication software (e.g., Hercules) by
connecting a PC to the serial or Ethernet port on
VP-440
. To enter
CR
press the Enter key
(
LF
is also sent but is ignored by the command parser).
Commands sent from various non-Kramer controllers (e.g., Crestron) may require special
coding for some characters (such as,
/X##
). For mor
e information, refer to your controller’s
documentation.
